Brandt Optimat KD79 Edgebander

$23,900.00

Out of stock

Category:

Description

Brandt Optimat KD79 Edgebander   2002, very good working condition

Description:

  • Premill
  • Corner rounding
  • Buffering
  • Automatic height adjustment with top pressure beam for all work stations; digital height indicator
  • PC-16 Program Control: • Passive matrix Color LCD screen, 7.4”, VGA standard resolution of 640 x 480. • 8 mb IDE Flash Disc 100 mhz 486 DX4 Hard Drive • 8 mb RAM • Internal Modem for remote diagnostic link
  • Signal light at infeed to insure proper spacing of panels
  • Joint trimming / Pre-milling unit for pre-trimming the workpiece edges
  • Four roller pressure zone.
  • End trimming unit with straight and chamfer capability. Chamfer up to 15 degrees
  • Pneumatic indexing via program control; Fine trimming unit #1 with digital “Quickset” system; tilt range 0 – 25 degrees; Pneumatic indexing via program control; Fine trimming unit #2 with digital “Quickset “ system; tilt range 0 – 25 degrees
  • Contour trimming unit for profile corner trimming.
  • Sound enclosure with centralized dust extraction outlet
  • Scraping unit for rigid PVC edges; buffing unit
  • Electronic frequency changer for all trimming motors which also incorporates electronic motor brakes
  • Edge cap: 0.4-13mm (1/2″); Panel thickness: 5/16″-1-9/16″; Min. panel length: 160mm (6-3/8″); Min. panel width: 65mm (2-1/2″)
  • (2) 3HP – 12,000 RPM vertical pre-milling/jointing heads
  • Large coil table 800mm diameter to accommodate large coils of 3mm PVC
  • PLC controlled chamfer from 0-15 degrees

 

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.